Important Notes:
Please observe the operation, safety instructions. To avoid the risk of
electric shock of being in a long hood and ensure safe operation.
1. Keep clean.
2. Suitable for indoor use.
3. Before using, make sure the power supply to the correct voltage rating.
4. The fixture should be placed horizontally, not tilt or flip. And install it in a
fixed place, because when it projecting, the power is very strong.
5. After use, you should turn off the power or unplug.
6. The fixture is not waterproof, if moisture or water inside the machine
invasion, should cut off the power immediately and contact your dealer.
7. Inside of the machine is not included user-serviceable parts, please
consult your dealer or qualified service personnel.
To avoid the risk of fire, please note that (security warning):
1. Only for adults. The fixture should be installed in the children can not
touch the place, in use, will always pay attention.
2. Not directly sprayed into the human body, should stay away from the
flames
3. Extremely hot spray of CO2, so the use of the above should be kept a
safe distance from the nozzle 100CM. (Surface temperature of 40-80 C,
do not touch)
4. The fixture should be installed in a well ventilated area, not cover the
vents on the hood to ensure proper ventilation.
20CM kept to a minimum and down around the space, while not store
combustible materials within the surrounding 300CM. (Away from the
carpet, wood and combustible material). To avoid the danger of
explosive.
5. Please note: not add flammable liquids, such as oil, gas or spices in oil
drums into.
Operation Instruction:
1. Put the fixture on the flat surface and installed it in a fixed place. There
are 4 plastic corners on the bottom of the fixture, need to take them off
and use the screws to install it strongly.
2. 4 units can be connected in series via special pipes and DMX512 cables
If you choose manual control, put the button “ON”, but please note that
Operation Instruction:
1. Put the fixture on the flat surface and installed it in a fixed place. There
are 4 plastic corners on the bottom of the fixture, need to take them off
and use the screws to install it strongly.
2. 4 units can be connected in series via special pipes and DMX512 cables
If you choose manual control, put the button “ON”, but please note that,
you choose this mode, after turn on and then need to turn off to
close the valve, otherwise it will project CO2 continuously.
3. You can adjust the height of projecting of CO2 by adjusting the
switch of charging bottle
4. After using, please let the machine project all CO2 inside of the
machine and then turn off the switch (it is better put it on the
OFF) and close the switch of the charging bottle
Back Panel Instruction:
DMX: In DMX512 control mode (after 3 seconds, reposition to
close the valve)
OFF: Close (operation switch)
ON: Manual switch for valve
