4x200W Blinder Strobe warm Audience led stage lighting

Specification

SOURCE

4*200W white and warm white 2-in-1 LED COB

50,000 Hours LED Lifetime (May vary depending on different factors)

FUNCTION

Audience blinder and strobe 2-in-1

4*200W white and warm white 2-in-1 LED COB

New advantage optic Lens, optimal cooling system

Independent LEDs control

IP65 Waterproof

High density Die-cast aluminum all body

55° Beam Angle

± 25° Pan manual adjustment per pod

3 Variable Dimming Curve Modes

Adjustable electronic Shutter/Strobe

Flicker free

Extremly quiet fans

CONTROL & CONNECTIONS

(3) DMX Channel Modes (2/9/16 channels)

LCD Menu Display

3-pin XLR Sockets

PowerCON Power In/Out

DMX512, Auto run, Sound, Master/Slave

THERMAL & ELECTRICAL

800W max Power Consumption

Input voltage: 100-240V AC/50-60 Hz

APPROVALS / RATINGS

CE | RoHs Compliant | IP65

SIZE / WEIGHT

17.7" (450mm) Length

17.7" (450mm) Width

6.3" (160mm) Height

33 lbs (15 kg) Weight

First of all thank you for using our products, it USES the current of the world's most advanced light source -- cold light LED as light source, to overcome the traditional light source power consumption is large, short service life, temperature higher shortcomings, the advantages of low power consumption, long life span (normally can reach about sixty thousand hours), high brightness, colorful, etc. Is the current stage lighting and various effect decoration ideal products.

Security is introduced

1. This lamp belongs to class I protection equipment, so the lamps and lanterns must be well grounded. Be connected by a professional.

2. Confirm that the use voltage shall not be above or below the specification of the instruction manual.

3. Confirm that the power cord is not cut or damaged by the sharp blade.

4. The lamp must be disconnected before cleaning.

5. Only allow the plug to connect the power cord, please do not pull the power cord to pull the plug when pulling plug.

6. Be careful in the installation of light fixtures, avoid touching exposed wires, or you will be subjected to lethal electric shocks.

7. Please do not look directly into the light source while using the lamp, or your eyes will be hurt.

8. When choosing the location of installation, make sure that the lamps are not exposed to extremely hot, humid or dusty places. The distance between the luminaire and the illuminated object must exceed half a metre. Ensure there is no flammable and explosive material within 0.5 m distance.

Please use appropriate and safe wire connecting lamps.

10. Please operate after familiar with the function of lamps. Most of the damage to the lamp is due to improper operation, so it is not allowed to operate the lamps. Do not shake lamps and lanterns when use, do not rough operation.

11, please do not modify lamps, lamps and lanterns of doing so may cause a short circuit, the phenomenon such as burning, electric shock, and thus caused the failure and damage of lamps and lanterns, the manufacturer will not be warranty.