Description
CO2 jet machine is awesome machine without LED Ring, Four jet machine connection can be use together, small and lightweight but powerful visual effect, it is very good design. very suitable for DJ, wedding, events. etc.
Features
*Column Height：8-10(m)
*Adjusting Angle: 90 degree
*Control Mode：DMX-512, Manual
*Without LED Ring
Specification
FUNCTION
*Column Height：8-10(m)
*Adjusting Angle: 90 degree
*Control Mode：DMX-512, Manual
*Without LED Ring
*Package Included: Power cables, jumper power connectors(without cables, you can DIY different length jumper cables), 2 meters DMX cables, 5 meters length high-pressure Pipe（not included CO2 cylinder, buy in your local）
CONTROL & CONNECTIONS
* (1) DMX Channel Modes (7 channels)
* Digital Display
* 3-pin DMX In/Out
* PowerCON Power In/Out
* DMX control, Manual
THERMAL & ELECTRICAL
* Input Power：AC 110V or 220V, 50-60Hz
* Power Consumption：70W
* Working Pressure: 5Mpa
* Co2 consumption Rate: 0.35kg/S
APPROVALS / RATINGS
CE | RoHs Compliant | IP20
SIZE / WEIGHT
* Net Weight: 15lbs (6.8kg)
* Machine size: (17.7"x 13.8"x11.8") 450x350x300mm
Operation Instruction:
1. Put the fixture on the flat surface and installed it in a fixed place. There
are 4 plastic corners on the bottom of the fixture, need to take them off
and use the screws to install it strongly.
2. 4 units can be connected in series via special pipes and DMX512 cables
If you choose manual control, put the button “ON”, but please note that,
you choose this mode, after turn on and then need to turn off to
close the valve, otherwise it will project CO2 continuously.
3. You can adjust the height of projecting of CO2 by adjusting the
switch of charging bottle
4. After using, please let the machine project all CO2 inside of the
machine and then turn off the switch (it is better put it on the
OFF) and close the switch of the charging bottle
Back Panel Instruction:
DMX: In DMX512 control mode (after 3 seconds, reposition to
close the valve)
OFF: Close (operation switch)
ON: Manual switch for valve